High-voltage protection for vehicles
Marten repellent for vehicles with high voltage and acoustic signal.
MARDERfix-HIGH-VOLTAGE KP
Marten defense with high voltage according to the pasture fence principle
Marten defense with high voltage according to the pasture fence principle and acoustic sine tone signal – “If you don’t want to hear, you have to feel”.
The marten repellent device produces a very high sine tone of approx. 23 kHz, almost inaudible to humans. The marten finds this frequency extremely unpleasant. He will avoid this area.
In addition, six high-voltage plates deliver an effective electric shock of between 300 and 700 volts when touched. This is absolutely harmless to humans and animals, but repels the marten permanently.
Also offers protection from rodents.
| Feature | Value |
|---|---|
| Operating voltage | 12 Volt DC |
| High voltage | 300-700 Volt DC |
| Power consumption | approx. 30 mA |
| Frequency range | 23 kHz +/- 10% |
| Sound pressure | approx. 85 dB |
| Beam angle | approx. 140° |
| Fuse | available |
| Guarantee | 2 years |
| Article no. | 06506 |
| Devices Length in mm | 120 |
| Device width in mm | 68 |
| Device height in mm | 30 |
| Weight pcs. incl. Verp. in g | 240 |
Installation of the high-voltage device
The sine tone works like the beam of a flashlight and does not penetrate matter.
Install the device in the upper half of the engine compartment so that the sound can spread as freely as possible
01 Pre-treatment with pre-cleaner
The surface to be protected must be thoroughly cleaned before use! We recommend our pre-cleaner Art. no. 06503. After a short exposure time, rinse off the foam thoroughly (e.g. with a watering can). The vehicle is therefore neutral.
02 Connecting the acoustic device
Connect the positive cable (RED) with fuse to 12 V positive after the fuse box. Connect the negative cable (black) to the ignition-switched positive (= terminal 15).
03 Placement of contact plates
Position and fasten the individual contact plates (e.g. with cable ties) so that the conductive bare surfaces of the plates do not touch any other parts. Switch on the appliance (green “On/Off button”). Control function light is active.